HDK 1.3 to 1.4 upgrade kit

 

image1

Rev 20160722

PACKAGE CONTENTS:

Face foam
Cleaning cloth
Image quality enhancer film
Film wiper

STEPS FOR APPLYING THE 1.4 UPGRADE KIT:

1. Starting from the bottom, peel off the old face foam.

image2

 

2. Apply the new face foam to the HMD.

image3

3. Place the HMD module on a clean, smooth, flat work surface.

image4

Note: You may use the foams on the HDK packaging box as an alternative work surface. It’s recommended that your environment is humid to prevent dust and static. Remember to keep your hands clean during these procedures.

 

4. Remove the screws from the bottom of the HMD module.

image5

5. Carefully open the front panel in a counter- clockwise direction.

image6

Note: It may require a bit of force to detach the magnetic locks. Avoid yanking the front panel so as not to damage the ribbon cable.

 

6. Remove the screws from the cable holder.

image7

7. Cautiously lift the cable holder.

image8

 

8. Carefully detach the connectors shown here.

image9

9. Gently lift the rubber cables from the top of the HMD module.

image10

 

10. Carefully detach the connectors shown here.

image11

11. Remove the screws from the HMD module.

image12

 

12. Carefully lift the display module.

image13

13. Set aside the HMD module.

image14

 

14. Flip and place the display module on your work surface.

image15

15. Wipe clean the display module using the cleaning cloth provided.

image16

 

16. Without peeling, place the film with the “F” facing you on the display module to gauge the correct placement.

image17

17.Peel a small portion of the back plastic cover of the film and place it on the display module.

image18

 

18.Starting from the middle, use the wiper to carefully push away the air bubbles trapped between the film and the display module.

image19

19.Continue peeling and removing the air bubbles until the film is fully applied to the display module.

image20

 

20. Carefully remove the front plastic cover to avoid peeling off the entire film.

image21

21. Gently lift and flip the display module and place it into the HMD module.

image22

Note: Avoid touching the film so as not to accidentally leave fingerprints.

 

22. Reinsert the screws to the HMD module.

image23

23. Carefully attach the connectors shown here.

image24

 

24. Gently place the rubber cables to the top of the HMD module.

image25

25. Carefully attach the connectors shown here.

image26

 

26. Place the cable holder to the HMD module.

image27

27. Carefully close the front panel of the HMD module.

image28

 

28. Reinsert the screws to the HMD module.

image29

Congratulations, you have successfully applied the 1.4 Upgrade Kit to your OSVR HDK!

Leave a Reply 0

Your email address will not be published. Required fields are marked *


This site uses Akismet to reduce spam. Learn how your comment data is processed.